How to install the SPC/LVT Click floor?

When we want to renovate our house, as labor costs are getting higher and higher, we will consider buying LVT/SPC click floor that can be DIY, then how to install the lock floor, the following five steps tell you.

INSTALLATION STEPS

❶Place the horizontal line or place the first floor from the upper left corner of the room and place its two tenon edges against the wall. In order to prevent the natural expansion of the floor, a space of about 8-10mm should be reserved between the floor and the wall.

❷When installing the second piece of the first row, place the tenon edge of the second piece in the groove of the first piece, tap it hard or tap it lightly with a rubber hammer, and continue to use the same method. chip installation.

❸Begin to install the second row, use the remaining part cut from the last piece of floor in the first row (not less than 20cm), install it on the first piece of the second row, insert the tenon of the long piece into the first row of the floor during installation. in the groove.

❹When installing the second piece of the second row, insert the long side of the second piece into the groove of the first row, align the tenon with the groove of the first piece of the second row, and tap it hard or lightly with a rubber mallet Just tap it, and continue to use the same method to install the next piece.

❺Finally, use the same method to install other floors in the room. It is necessary to pay attention to leaving the necessary expansion gap between all the fixed objects or walls in the room (including fixed furniture such as walls, door joints and cabinets.