Coating And Scraping Process Of PVC Coil Floor Secrets Revealed

The coating and scraping process is a production process of PVC coil floor.

In addition to the extrusion process and the rolling process, the PVC coil floor also has a coating and scraping process. If the material of extrusion process and rolling process is powder, then in this process of coating and scraping process, the material is liquid.

The production process of PVC coil floor using the scraping process.

The first is the glass fiber layer, and then the coating is carried out. The coating is divided into front coating, back coating and then front coating. It is worth noting that the PVC material at this moment is in liquid form, which is different from the extrusion process and the rolling process. The state of the raw materials used is different. The substrates of the extrusion process and the rolling process are all powdery. The coating and scraping process allows the raw materials to slowly adhere to the glass fiber layer. During this process, the liquid slowly flow.

Then the process of heating and water cooling is carried out. After this process, the high temperature lamination of the printing layer and the wear-resistant layer will be carried out successively. After the printing layer and the high temperature layer are laminated, the semi-finished product will be trimmed. After the edge is completed, UV coating will be carried out.

Finally, it is rolled into large rolls and the large rolls will be cut into small rolls and quality checked.

Although the process of the coating and scraping process will be more complicated, the equipment to be used will be more, and the energy consumption and labor will be more, and the overall cost will be high, but in terms of product stability, it is more stable, and the quality inspection is relatively sufficient, almost no defects, but its packaging is divided into standard and non-standard rolls.